Paldiski mnt.26A, Tallinn
+372 50 64 135
Топ продаж
Новые товары
Кофе Nescafe Дольче Густо Гранде Intenso 16 капсул в коробке
With the TC2 heat press Secabo shows up with the right press for the introduction into textile finishing and other transfer techniques\. On the digital controller of the Secabo TC2 time and temperature for the transfers can be set\. After the transfer is done, an acoustic signal sounds\. The contact pressure is adjusted by a hand wheel on the upper side of the heating plate\. The pressing operation starts when the pressing lever is closed\. The large opening angle allows comfortable preparing of the transfer objects on the base plate\. The TC2 has a working area of 23cm x 33cm and a heating plate with a power consumption of 1\.000W\.
Cheap heat press for beginners
Mobile press for on-site use at events and merchandising
Large opening angle
Digital controller for temperature and time
Cheap heat press for beginners
Mobile press for on-site use at events and merchandising
Large opening angle
Digital controller for temperature and time
EAN:PIGU35288116
Чистящая жидкость печатающих головок OCP “Nozzle Rocket”, 250 ml
Liquid is designed for unclogging \(internal rinsing\) of ink cartridges\. Its specially working out chemical composition allows to remove \(dissolve\) very precisely the reminders of dry ink from the cartridge\.
This liquid is an auxiliary liquid and should be used jointly with
OCP
internal yellow liquid\. Simply -
Nozzle Rocket
removes all the dry ink remainders which wasn't dissolved after use of yellow liquid\. Use
Nozzle Rocket
liquid only injecting it inside the cartridge\. We receive the best effectiveness when liquid will be heated to temperature
55 °C
\. It is very important not to cross that temperature! Because the electronic plates are stuck, too large temperature of solution may cause plates unstick and also cartridge electronic damage\. Injecting liquid inside the cartridge it is necessary to remember to suck off using syringe with suction device through the exhaust nozzles \(alternatively using specialist suction device\)\.
ATTENTION
: We receive the largest effectiveness when the liquid is heated to
55 °C
\. Don´t cross that temperature! After cartridge rinsing with
Nozzle Rocket
liquid, it is recommended removing liquid reminders injecting inside the cartridge distilled water and removing reminders sucking it off through exhaust nozzles\.
EAN:0